IAPMO IGC 354-2020a

Pipe Lining Systems Employing Polyethylene Terephthalate (PET)
standard by International Association of Plumbing and Mechanical Officials, 2020

IAPMO IGC 348-2020

Plastic Push Fit Tubular Fittings
standard by International Association of Plumbing and Mechanical Officials, 2020

IAPMO IGC 364-2020

Compression Molded Corrugated Thermoplastic Tanks
standard by International Association of Plumbing and Mechanical Officials, 2020

IAPMO /ANSI/CAN/ISO 30500:2019

Non-sewered sanitation systems – Prefabricated integrated treatment units – General safety and performance requirements for design and testing (ISO 30500:2018, IDT)
standard by International Association of Plumbing and Mechanical Officials, 2019

IAPMO IS 32-2020e1

Chemical Dispensing Equipment with Backflow Protection
standard by International Association of Plumbing and Mechanical Officials, 2020

IAPMO IGC 138-99 (R2013)

Air Gap Drains for Commercial Kitchen Sinks
standard by International Association of Plumbing and Mechanical Officials, 1999

IAPMO 150-2007

Vacuum Sewage, Grease Waste and/or Condensate Collection Systems
standard by International Association of Plumbing and Mechanical Officials, 2007

IAPMO IGC 119-2019

Water Treatment Equipment Drain Connectors
standard by International Association of Plumbing and Mechanical Officials, 2019

IAPMO IGC 122-2019

Test Caps and Test Gates with ABS or PVC Housings
standard by International Association of Plumbing and Mechanical Officials, 2019

IAPMO IGC 120-2019

Elastomeric Gasketed and Rubber-Ring Joint Fittings for Hot and Cold Water Distribution Systems
standard by International Association of Plumbing and Mechanical Officials, 2019